Hydrosphere Technologies

  Watch for our NEW line Of HydroTECH Sentraforce Products coming soon !

10 Reasons to Buy our Products

 1. Increase your fuel Mileage 30 to 50 %

   2. Save money at the pump

     3. Lower Emissions

       4. Get better engine performance

         5. Built to last

            6. Dependable

              7. SAFE

                 8. Economical

                    9. New 1 year warranty

                       10. IT PAYS FOR ITSELF

If you are using a hydrogen generator on you car/truck you will need this unit to lean the fuel mixture ratio to get the most fuel economy out of your vehicle.  Running just the generator will cause the O2 sensor to read to much oxygen in the exhaust and send a signal to the computer that will increase the fuel pressure to the injectors that will decrease the miles per gallon of your vehicle.  Installing the Enhancer will allow you to lean the signal from the MAP or MAF allowing your car to use less gas and more hydrogen gas in the intake that will result in more money in your pocket.  Each unit is bench tested to insure a quality product.  Enclosure has plenty of space around the adjustment knobs for you to make those sweet spot marks where your vehicle runs the best.  Believe me those marks will save you alot of time.   Installation:  The GREEN wire is hooked to ground, BLACK is hooked to the MAP or MAF sensor side, and the WHITE is hooked to the computer side.  FULL simple installation and adjustment instructions are included in each of these units.  The unit can be mounted on the firewall under the hood or you can extend the wires into the driving compartment so you can make adjustments on the fly.  Knobs are subject to change color & shape according to availability.   Adjustment:  With the engine running and the Enhancer in the enhanced mode, select the City side of the unit.  Turning the adjustment knob clockwise until you hear or feel the idle of the engine stumble or slow.  Then turn the knob counterclockwise until the engine smooths out. You can use the other adjustment for Highway setting (leaner) to achieve more MPG or you can use it for cold starts.  It is totally up to you.    WARNING:  IT IS POSSIBLE TO LEAN YOUR MOTOR TO MUCH AND CAUSE DAMAGE.  IF AFTER READING THE INSTRUCTIONS ON ADJUSTMENT AND YOU STILL DON'T UNDERSTAND, THE BEST THING FOR YOU TO DO IS FIND A MECHANIC THAT CAN HELP YOU.   SINCE I AM NOT INSTALLING THE UNIT OR ADJUSTING THE UNIT I AM NOT RESPONSIBLE FOR ANY DAMAGE THAT CAN OCCUR IF INSTALLATION AND ADJUSTMENT ARE NOT CORRECT.  BOTH INSTALLATION AND ADJUSTMENT ARE EASY BUT IT HAS TO BE CORRECT.     $39.99

Understanding HHO Gas and how its made

   As gas prices sky rocket, we needed to find a cost effective solution to drive down the price of fuel. We started our research into hydrogen fuel in the late 90's when gas was just beginning to rise, Now we needed to find a way to make hydrogen fuel on demand and without costly effects to the consumer, so we created an HHO generator as we call it, Its simply H2O (or water) which we in turn separate the water molecules into two parts hydrogen and one part oxygen. When separating both molecules we create two flammable gases which now can feed into an internal combustion engine. You might ask how will my car or truck run on hydrogen and oxygen. Well it is very simple we inject hydrogen and oxygen into your car or trucks vacuum line which in turn will feed into the combustion chambers along with the fuel you are already using. When hydrogen gas or oxygen gas is burned it produces zero emissions just harmless water vapor. Adding HHO to your vehicle not only will make your car or truck run better it will also save you money at the pump.

   Water separation explained, We use 316L stainless steel plates in our generators. When passing DC voltage through water you start to see a reaction, small bubbles rising from the plates. Well these bubbles are hydrogen and oxygen. The positive plates produces hydrogen and the negative plates produce the oxygen. Your vehicle already has a battery which produces 12 to 14 volts of electricity, Enough power to produce 1 to 4 liters of gas per minute, that's incredible! We use stainless steel in all our generators, the reason is when producing these gases regular metals would rust very rapidly, this is why stainless is superior.

   In most vehicles from the early 90's up have fuel injection which is controlled by a computer, when taking HHO into a newer vehicles engine, the computer will recognize this and will in turn adjust your fuel output to compensate for the HHO gases. The problem with new cars or trucks is that the computer sees a higher output of oxygen that its used, so it dumps more fuel into the combustion chamber, this is what we are trying to avoid at all cost, so we offer a small unit which will correct this problem. Most vehicle from 1990-2008 have two sensors, one is called an O2 sensor which adjusts your fuel output by the amount of oxygen being emitted into your exhaust, the other one is your mass air flow sensor which is much like the O2 sensor but controls much more of the vehicle fuel and timing attributes. The mass air flow sensor measures the air coming in to adjust the fuel needed and also adjust the spark plugs timing. Our device will tap into the mass air flow sensor and give you full control of your fuel usage. When turning this device on it bypasses the MAF or the MAP sensor so you can dial the right mixture in. We call this unit E.F.I.E Electronic Fuel Injection Enhancer, A very important device that is a must for the HHO generator to be efficient.

   Hydrosphere Technologies is committed to manufacturing hydrogen generators that are safe, efficient, and economical for the consumer.